screen printing > DIY - From master engineered marvels to cobbled together jury-rigged or Jerry-built junk!
anyone ever built a screen holder for emulsioning?
KevWilso:
http://www.vastex.com/Literature/C-100%20Flyer-NP.pdf
Vastex just came out with a new one like a week ago. I haven't seen it in person yet though. Looks pretty nice.
ebscreen:
We have a Saati one. It's nice, adjustable, I'll try and get a pic later. Not much to it in terms of fabrication.
Denis Kolar:
Just build yours, do not buy it :)
tonypep:
Thanks Orion there it is. Hydraulic shock is mounted to bottom screen holder. Do not need to adjust for screen frame sizes. Just height of person coating.
jvanick:
Here's ours... I personally don't like the ones that only hold the screen at the bottom.. too much flex in the screen and you don't get a consistent coating.
please no comments on the emulsion drips all over the place... we've gotten a LOT cleaner than we were when we started... :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version