"He who marches out of step hears another drum." ~ Ken Kesey
any of you guys care to measure the slant model i-image and let me know the dimensions and how big I need to make the door opening to get it in?Also, is anybody running these things on a UPS? We have a big 5kw UPS that used to be for a small datacenter that we run all the office computers and network stuff off of. I'm considering putting a separate drop into the screen room for it.
A big question for me still is backup; what if it breaks down? Do you still have the ability to produce film, and still have the vacuum frame?
For back up we will still have our 4880, film on the shelf, and a tri loc jig on our old MH unit. Keep our LED Starlight unit for our i-Image. So we should be good in the event of any problems, plus it's M&R, any issue would be resolved super fast im sure.
Quote from: Sbrem on September 06, 2014, 10:03:22 AMA big question for me still is backup; what if it breaks down? Do you still have the ability to produce film, and still have the vacuum frame?This would be a concern of mine... if you are big enough to afford DTS, then you are big enough that you can't afford to have it go down either!
You say minimal but don't you have to print a whole job of screens then go back through the screens again and print the other side? Rich, are you reading this? I assume some mechanism locks it in the tri-loc position? Well, why not have the same mechanism on the opposite side to print the other side all in one step? I haven't seen one up close but that would sell me.