screen printing > DIY - From master engineered marvels to cobbled together jury-rigged or Jerry-built junk!
New screen rack
Admiral:
Cut the edge of the wood at an angle before screwing them in place and with that angle you are almost screen safe. Add a smooth strip of plastic over top of that and now it is almost impossible to bust a screen from the rack.
Screen holders like this \ / but not as steep.
Terrapin Tees:
i built my drying cabinet similar, and for the rails, home depot sells 2 foot straight lengths of black abs (i believe) for doing sprinklers, and such. they're about 1" diameter, maybe a little bigger. perfect.
mooseman:
If you look close you can see we used 1/2 " wood dowels in this frig conversion and 1/2" pvc pipe on the dryer cabinet.
mooseman
mooseman:
This hit me right after I posted, you can make a real cheap and dirty screen rack out of simple PVC pipe. A bit of a "moosegoldberg" arrangement but it can work estimated cost under $40.00.
Hope you can read the moose scratching ;)
Gilligan:
Did you slip in the bathroom and hit your head on the toilet when this came to you?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version