print settings from Corel X6, I need help.

[Doug S]

I have Corel x6 and was doing great until they notified me that there was an update.  After the update is when I started getting blank pages with just the reg marks.  I have the print settings the same as before but after the update something got screwed up.

[Im-Magic]

I have a problem with X^ and my OKI C8800 colour A3 Laser. Prints fine from X4 but leaves whole pieces of the drawing out in X6. I will sometimes give an error message as well but it is a pain in the A as I love the powerclip that now works properly and the eyedropper that works but the problems are vexatious

[inkman996]

And this is the reason I manual set up all my separations. I never use spot colors or built in registration marks etc.

I have the exact same issue with X5 and FM. If I have more than one color when I send to print it will always send all the plates no matter if i check them or not. It is irritating to say the least. My solution is after I set up each sep to black I then convert them all to high res rasters and send to the RIP. Never have to worry about plates etc.

[Stinkhorn Press]

I have a problem with X^ and my OKI C8800 colour A3 Laser. Prints fine from X4 but leaves whole pieces of the drawing out in X6. I will sometimes give an error message as well but it is a pain in the A as I love the powerclip that now works properly and the eyedropper that works but the problems are vexatious

Good to hear more voices on this.
Back with X4 and I agree, I'll miss some of the ACTUAL USEFUL UPDATES they've built in (eyedropper is a yes!).
But it looks like Corel never got around to sorting these issues out (i was running an un-updated early version of X6 - was hoping the updates cleared this up, but that's looking like a big fat no.

[prozyan]

I run X6 with Accurip, but have never had a problem.

[Frog]

I run X6 with Accurip, but have never had a problem.

ah, the plot thickens