we were running a underbase job yesterday, in order to get the white to pop, we needed to print flash print flash and then print the top layer... pretty typical job..
we've been running the performance white typically, but this time decided to use the quick white we had left over.
no problem getting a very nice mat-down, and bright whtie.
the problem came with the second color on top. for some reason, if the white was still slightly tacky, we had bad issues printing the top layer (red epic ink)... what I felt was overflashing (around 7 seconds!!), made the top layer print just fine.
did a quick wash test and no problems, so I'm guessing that's the correct answer...
but I'm wondering if somebody could answer the WHY?
