Author Topic: Newman panel mesh  (Read 7991 times)

Offline Rockers

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2074
Re: Newman panel mesh
« Reply #30 on: February 07, 2014, 04:28:50 AM »
Just to follow up on this tread...
I just installed a Newman panel N300 mesh 23 x 31 for M3 into an MZX frame.
I ran into the same issue as the pictures that were posted with the mesh not reaching end to end. 
In order for the panel to be put in place I had to turn the rollers inward so that the channels were facing directly into the center of the frame.  I normally start with the rollers in a similar position as in the pictures posted earlier in the thread.

I was then able to get the mesh in place and stretched it to a quick 32 newtons.  I am not sure how far the roller will be turned when they are at a work hardened state, but as of right now it is not a lot.

I will post again when re stretched with details of my findings.
Tried that too, still it does not fit.


Offline sben763

  • Verified/Junior
  • **
  • Posts: 83
Re: Newman panel mesh
« Reply #31 on: February 07, 2014, 09:10:29 AM »
Someone may have goofed but the panels are made from a jig so size shouldn't be wrong. Just a FYI even the Newman panels are made by Shurloc.